Telephone +44 (0)1926 812066  



Industry recognised training courses in Calibration and Metrology

Chamois Metrology runs a range of acclaimed calibration training courses that are designed to enable laboratory, inspection, quality assurance, maintenance and certification personnel to meet the increasing need to demonstrate their competence.

Our courses are delivered by specialists in their field, which are designed to equip attendees with high-value knowledge and skills to make a practical difference in an organisation.


Our training courses can be held in a classroom environment, practical workshop setting or a combination of both. Here are some examples of typical courses:

  • Basics of Metrology and Calibration
    All topics are covered from Health & Safety, The SI Units of Measurement, Procedures, Methods and Equipment Selection, Troubleshooting, Common Mistakes, Theories and Calculations data analysis and basic uncertainties.
  • Getting the best from your Deadweight Tester
    Theory, Operation, Maintenance and handling, influencing factors, calculations and uncertainties. Practical workshops.
  • Introduction to Uncertainties of Measurement
    A practical guide and introduction with real world examples for your applications.
  • Understanding Metrology
    Pressure Calibration, Temperature Calibration, Electrical Calibration and Mass Calibration.
  • Differential Pressure Calibration at Elevated Static Pressures
    Methods, Procedures, Calculations, Errors and Uncertainties.

New purpose-built training facility
Our impressive new purpose-built training facility will greatly enhance the delivery of Chamois Metrology’s acclaimed training courses. Our well-developed and targeted training is highly rated by participants, who recognise the relevance of informed training from active industry practitioners.


Chamois Metrology draws on a wealth of knowledge and experience to deliver training courses specifically designed for each customer. They can be held at a customer’s site or at the new Chamois state-of-the-art facility at Southam, Warwickshire.

Contact Chamois Metrology